[Recovery21]

Originally Posted by 85_305

Jesse (recovery21) has a neat toolbox setup in the back of his T I think?

Kinda. I have a black Diamond plate toolbox in the backseat. I have all of my "Recovery" gear in there. I thought of the molded tool boxes that GM makes but they are expensive. I can't see spending $600+ on a plastic box. Plus, I have my CB antenna mount and Hi-lift mount utilizing the bed rails so I can't even get a box. I would have to reconfigure everything. Interesting to see what everybody comes up with!

[85_305]

Hey where was that pic taken? East Aurora?

[Recovery21]

Originally Posted by 85_305

Hey where was that pic taken? East Aurora?

It was taken at RC in the new property. Check my RC album on my page and I have more pics.

[85_305]

Oh ok I'll check it out. I'm pretty sure we're going to RC memorial day. Yipee

[H3TBone]

I just ordered this Dee Zee tool box (D378537) for $205 shipped to my door. Awesome deal. Use coupon: TPBCART

http://www.thepartsbin.com/catalog/?...82&Ntt=D378537

37.125 in. x 19 in. x 15.9 in.; 6.4 cu. ft. Same size as my poly box I have now, if not a little bigger. Like my poly box, if you mount it a little off-center, there is enough room left to the side for a jerry can mounted to the rail. It's aluminum finish, but I save ~$100 over the black powdercoated version of the box. I plan to have it Line-x'd or maybe try the duplicolor stuff with the cash I saved. I plan to mount it with some studs and butterfly nuts to make it removable.

[neverendingproject]

So here is my truck vault. Its got a lot of crap in it now, but it does carry a lot of stuff.

Right now I have it setup where it has three compartments. One small one to keep straps, etc. in and a larger one for tools. On the side there are two long areas where I can keep two shotguns.